Lesson 3 of 5

Running a physical count that holds up

A cut-off, the full list, the right unit, and a record made as you go.

▶ 1:38 video · 5 min read · 3-question check

In this lesson

  • Set a cut-off so no prescription is half in and half out of the count.
  • Count every line on the list, including zero lines and expired stock awaiting destruction. Patient returns are not inventory.
  • Count in the unit you dispense, and record each line as you go, with no erasing.
  • Health Canada's guidance says counts are done by a pharmacist or by someone under a pharmacist's direct supervision.

A count is a snapshot of the shelf at one moment. Months later, an assessor, a new manager or you may need to know exactly how a number was reached. These steps make the snapshot hold up.

  1. Pick the momentChoose a quiet time. Set a cut-off: every prescription is either finished and recorded before you start, or it waits until the count is done.
  2. Work from the full listEvery narcotic, controlled drug and targeted substance you stock, including lines you expect to be zero. A zero line that turns out to have stock is a finding too.
  3. Include expired and damaged stockStock waiting for destruction is still inventory until it is destroyed and the destruction is recorded. Keep it apart, labelled, and count it on its own line.
  4. Leave patient returns outUnder the Controlled Substances Regulations, patient returns are kept in a marked collection container in a secure place (s. 104). They are never dispensed again and never counted as stock.
  5. Count in the unit you dispenseSealed manufacturer bottles by the label. Open bottles by hand, on a counting tray. Liquids such as methadone by volume, in millilitres. Patches and ampoules one at a time.
  6. Count blind if you canWrite down what you count before you look at the expected number. It stops the count drifting toward the answer.
  7. Record as you goDrug, strength, DIN, quantity, the time and your initials. Never erase or use correction fluid: strike through once, write the new number beside it, and initial it.
  8. Close the momentWhen the last line is counted, note the date and time. That moment is where the next count's window begins.

Good entries and poor ones

EntryWhy it works or fails
Oxycodone 10 mg, its DIN, expected 80, counted 74, minus 6, 2:40 p.m., initialsEvery number is there, so anyone can check it later.
"count ok"No quantity, no time and no name. It cannot be reconciled later.
74 written over 76 with correction fluidNobody can tell what was first written, or why it changed.

Liquids, patches and packs

  • Measure liquids such as methadone in a graduated cylinder, in millilitres, to the precision your records use.
  • Count patches one by one. A box label is not a count once the box has been opened.
  • Decide how your pharmacy handles compliance packs and filled prescriptions waiting for pick-up, write it in your count policy, and do it the same way every time. If your records already show them as dispensed, they are not part of the count.

Check your understanding

3 quick questions. Answering them marks this lesson done. Your answers stay in this browser.

  1. 1.Where do patient returns of controlled substances belong during a count?
  2. 2.What does counting blind mean?
  3. 3.You wrote 76, then saw you misread it and the count is 74. What should the record show?
0 of 3 answered

Go deeper

Sources

Show the 4 sources

Primary sources for the figures on this page. Regulations change; confirm the current requirement with the source before you rely on it.

General information, not legal or professional advice. For authoritative requirements, refer to your provincial regulator and Health Canada.